Description:
| Battery: | 6-Volt | 12-Volt |
|---|---|---|
| Make | Auto-Lite | Auto-Lite |
| Model | IM-100 | 11-HS |
| Plates per Cell | 15 | 9 |
| Ampere-hour Rating | 100 | 50 |
| Terminal Ground | Negative | Negative |
| Specific Gravity: | ||
| Fully Charged | 1.260 | 1.260 |
| Recharge at | 1.225 | 1.225 |
| Height | 8 5/8" | 9 7/32" |
| Length | 8 23/32" | 10 15/64" |
| Width | 7" | 6 25/32" |
| Battery Location: | Under hood - Right side | Under hood - Right side |
| Generator specs: | ||
| Make | Auto-Lite | Auto-Lite |
| CJ-3A | GDZ 4817 | |
| CJ-3A late | GDZ 6001 | |
| Ground Polarity | Negative | Negative |
| Controlled Output: | ||
| 30 amp. | GJC 7002 | |
| 35 amp. | GDZ 4817, GDZ 6001 | GJP 7202, GJP 7402A |
| 45 amp. | GGW 4801, GGW 7404 | |
| Rotation - Drive End | Clockwise | Clockwise |
| Ratio - Generator to Crankshaft Revolutions | 1.5:1 | 1.5:1 |
| Cut-in Engine rpm | 883 | 883 |
| Control | CV Regulator | CV Regulator |
| Armature End Play | .003" to .010" | .003" to .010" |
| Brushes | 2 | 2 |
| Brush Spring Tension: | ||
| 35 to 53 oz. | GDZ 4817, GDZ 6001, GGW 4801 | |
| 18 to 36 oz. | GGW 7404A | GJC 7002, GJP 7202, GJP 7402A |
| Bearing - Drive End | Ball | Ball |
| Bearing - Commutator End | Bronze | Bronze |
| GENERATOR specs: | ||
| Make | Delco-Remy | Delco-Remy |
| Model | 11022811 | 1102096 |
| Type | Shunt (Ventilated) | Shunt (Ventilated) |
| Rotation - Drive End | Clockwise | Clockwise |
| Armature End Play | .005" [0,13mm.] | .005" [0,13mm.] |
| Brushes | 2 | 2 |
| Brush Spring Tension | 28 oz. | 28 oz. |
| Bearing - Drive End | Ball | Ball |
| Bearing - Commutator End | Bronze | Bronze |
| REGULATOR specs: | ||
| Make | Auto-Lite | Auto-Lite |
| For GDZ 4817, GDZ 6001 | VRP-6003, VRP-4007, VBO-4601 | |
| For GGW 4801, GGW 7004A | VBO-4601C | |
| For GJC 7002 | VRX-6009 | |
| For GJC 7202, GJP 7402A | VBO-4201E-4A | |
| Type | Vibrator | Vibrator |
| Cutout Relay: | ||
| Closing Voltage @ Generator rpm | 6.3 to 6.8 @ 1000 | 12.6 to 13.6 @ 1325 |
| Reverse Current to Open | 4 to 6 amp. | 3 to 5 amp. |
| Regulated Voltage | 7.1 to 7.3 | 14.3 to 14.7 |
| Regulated Current | 49 amp. max. | 39 amp. Max. |
| REGULATOR specs: | ||
| Make | Delco-Remy | Delco-Remy |
| Model | 1972063 | 1972029 |
| Type | Vibrator | Vibrator |
| Cutout Relay Closing Voltage | 5.9 to 6.7 | 11.8 to 13.5 |
| Regulated Voltage | 6.9 to 7.4 | 13.8 to 14.8 |
| Regulated Current | 42 to 47 | 27 to 33 |
| STARTING MOTOR specs: | ||
| Make | Auto-Lite | Auto-Lite |
| CJ-3A | MZ-4137 | |
| Rotation - Drive End | Clockwise | Clockwise |
| Engine Cranking Speed | 185 rpm. @ room temperature | 200 rpm. @ room temperature |
| Armature End Play | .005" to .030" | .005" min. |
| Brushes | 4 | 4 |
| Brush Spring Tension | 42 to 53 oz. | 31 to 47 oz. |
| Bearings | 3 Bronze | 3 Bronze |
| Lock Test: | ||
| Temperature | 70° F. (21° C.) | 70° F. (21° C.) |
| Amps (max.) | 335 | |
| MDM-6005 | 170 | |
| MDU-7004 | 280 | |
| Volts | 2.0 | 4.0 |
| Volts | 2.0 | 4.0 |
| Stall Torque: (min.) | 6.0 lb-ft. | |
| MDM-6005 | 1.5 lb-ft. | |
| MDU-7004 | 6.2 lb-ft. | |
| No Load Test: | ||
| Temperature | 70° F. (21° C.) | 70° F. (21° C.) |
| Amps (max.) | 65 | 50 |
| Volts | 5 | 10 |
| RPM (min.) | 4300 | |
| MDM-6005 | 4400 | |
| MDU-7004 | 5300 | |
| Control Switch | Solenoid | Solenoid |
| Drive: | ||
| Type | Bendix Folo-Thru | Bendix Folo-Thru |
| Pinion Meshes | Front | Front |
| No. of Teeth - Pinion | 9 | 9 |
| No. of Teeth - Flywheel | 129 | 129 |
| Flywheel Tooth Face Width | .375" | .375" |
| STARTING MOTOR specs: | ||
| Make | Delco-Remy | Delco-Remy |
| Model | 1108077 | 1107746 |
| Rotation - Drive End | Clockwise | Clockwise |
| Engine Cranking Speed | 185 rpm. | 185 rpm. |
| Armature End Play | .005" to .050" | .005" to .050" |
| Brushes | 4 | 4 |
| Brush Spring Tension (min.) | 24 oz. | 35 oz. |
| Bearings | 3 Bronze | 3 Bronze |
| Lock Test: | ||
| Temperature | 70° F. (21° C.) | 70° F. (21° C.) |
| Amps | 600 | 435 |
| Volts | 5.0 | 10.3 |
| RPM (min.) | 6000 | 6900 |
| Control Switch | Solenoid | Solenoid |
| COIL: | ||
| Make | Auto-Lite | Auto-Lite |
| All Models After CJ-2A | CR-6009, CAL-4001, CAL-4001-A, 200576, 200577, 200488 | CAF-4003, CAG-4002, 200562, 200574, 200564 |
| Amperes: | ||
| Engine Stopped | 5 @ 6.3 V | 2. to 82.9 @ 12.5V |
| Engine Idling | 2.5 | 2.8 to 2.9 |
| DISTRIBUTOR specs: | ||
| Make | Delco-Remy | Delco-Remy |
| Model | 1112432 | 1112432 |
| Spark Advance - Centrifugal | ||
| Start | 0° @ 425 rpm. | 0° @ 425 rpm. |
| Maximum | 10° to 12 ° @ 1950 rpm. | 10° to 12 ° @ 1950 rpm. |
| Breaker Gap | .022" | .022" |
| Cam Angle | 25° to 34° | 25° to 34° |
| Breaker Arm Tension | 19 to 23 oz. | 19 to 23 oz. |
| Condenser Capacity | .2 mfd. | .2 mfd. |
| TIMING specs: | ||
| Crankshaft | 5° BTC @ Idle | 5° BTC @ Idle |
| Mark Location | ||
| CJ-3A | ||
| Firing Order | 1-3-4-2 | 1-3-4-2 |
| SPARK PLUG Specs | ||
| Make and Model | Champion J8 | Champion J8 |
| Thread | 14 mm. | 14 mm. |
| Thread Reach | 3/8" | 3/8" |
| Gap | .030" | .030" |
| LAMP BULB TRADE NUMBERS: | ||
| Headlights | 5040-S or 6006 | 5400-S or 6012 |
| Parking Lights | 63 | 67 |
| Park and Directional Signal | 1158 | 1176 |
| Stop, Tail and Directional Signal | 1158 | 1034 |
| Indicator Lamps: | ||
| Headlight Beam | 51 | 53 |
| Directional Signal | 51 | 53 |
| Charge | 51 | 53 |
| Oil Pressure | 51 | 53 |
| Instrument Lamp | 55 | 57 |
| Flasher, Directional Signal | P229D | 524 |
| Fuse Data: | ||
| Directional Signal | SFE 14 | SFE 9 |
| Heater | SFE 14 | SFE 9 |
* Learn more about electrical from the Service Manual for Universal Jeep Vehicles page 152
RELATED VIDEOS:
